Recording indicator lights when the device is recording. When SD card 1 exist, it will light. When SD card 2 exist, it will light. Electronic lock indicator light, electronic lock open when bright. Infrared receiver, used to receive remote control signal.
Lock the electronic lock, the device can boot, electronic lock open, it will shut down. When the electronic lock is open, you can open the SD card interface baffle, according to the machine model, you can insert 1 or 2 SD card, or SIM card, electronic lock, do not force open SD card interface baffle, otherwise.First channel audio, video input interface. Channel audio, video input interface. Audio, video analog signal output interface. 3G / 4G antenna interface. 3G / 4G network antenna interface, external 3G dedicated antenna, 3G antenna to be placed in the absence of shielding, no interference. (Note: only with 3G / 4G / WIFI function models have the interface). Alarm input, alarm output, 232,485 and other signal interface, the specific definition of reference 1.6.4 section. USB interface (some models this function is valid). GPS antenna interface, external GPS dedicated antenna, GPS antenna to be placed in the unshielded, non-interference areas. (Note: only with GPS / Beidou models have the interface). There are introduction and app. 4 x camera extension cord. 1 x audio output cable.
1 x receiver extension cord. 2 x hot silica gel. Q:When Device issue appear, you are confused on how to solve it. A:Check Device Item No & Firmware Version, sent back to us with detail description of issue. Our Technical Team will handle it.More detail you described, easier for us to solve it quickly. Check situation of DVR:Device Input Power;Power Cable Connection;GND Connect to battery;fuse;RED & Yellow Cable of Power must connect together. Check the Screen Power or Check if the Screen change to related AV Channel. Check the connection of Video Output & Screen Cable. A:1Check working power, if low power device will keep rebooting. 2HDD/SD Card error, remove storage device and turn on device checking. Q: If the video input interface of the device and camera is different. A:The DVR is using 4 needle type port, the camera is BNC port or Aviation, if it is different, please use the X-over to connect, or connect according to the DVR Line sequence definition. Q:Device on with HDD but not recording. A:1Check SD/HDD if format;if not please enter Main GUI--System Set--Format, format HDD/SD Card. 2If close Recording , or set Timed Recording mode, if yes it wont recording if not the time set.
3If the HDD is connect well, if the HDD/SD light is on. Q: Video files lost, or there is no video files at a certain period time. Analysis the lost video and ensure the lost time period. Confirm if the DVR was opened at that time, such as crashed midway park, loading and unloading ect. And the device didnt set the delay recording.
Q: Can not control the Car PTZ, can not rotate to all direction. A: If the agreement and Baud rate of the PTZ is setting right, if the address code is corresponding, if the video channel is setting to max when control the PTZ. Like if is control the first channel, then must set the first channel image to be max. Q: With GPS but no GPS coordinate Information. A:1Check if GPS module exist.
2Check GPS Antenna connection, suggest install on the outside place with strong signal. 3If testing in office, suggest put GPS Antenna out of window. 4If working environment not good will related to no GPS Information or wrong information.
Q:Deviation of GPS Location on Map? A:The signal is effective if the GPS module has been positioning, there are so many reasons caused bias, government restriction, permissible error, GPS signal break off, The actual satellite map error occurred for the security, GPS Correction can solve the problem. 3G Wireless Module related FAQ. Q:If using 3G , what should we concern? A:1Choose inside wireless module WCDMA, EVDO, TD-SCDMA, relative module setting is different then SIM Card is different, please make sure the module is corresponding with the SIM Card.2If Server IP & Port set correct, if 3G signal strong for dialing;3G dialing successfully or not. 3Check 3G Antenna connection, dialing will be failed if 3G signal too weak. 4Check SIM Card 3G Flow. Q:When meet device offline or no video, what should be done first? A:1Press INFO key to enter the system Info page, check if SIM Card exist, 3G signal and dialing status, Antenna connection, Check SIM Card 3G Flow, change to a new SIM Card check again. 23G Signal strong but dialing fail, check if center IP & Port set correct. 3Check if Device ID already be occupied.
Q:3G Signal is intermittent, video get stuck? A:At present, signal coverage of the WCDMA and EVDO is very wide, but still there are some mountain area signal is weak, this will influence. Then check if the frame rate in Sub-stream setting is too high. Q:WIFI Signal 60/100, connect failure. A:General condition, connection is no problem when the signal intensity up to 60/100 if WIFI setup are right.
If the device can not be found in LAN, then you should check if setting SSID and password, IP Address, besides, check the Encryption Type and authentication mode if setting according to requirements. Q:Device working but can not see Vehicle and video on client software.
A: 1Check if Center Server running and device Number if using. 2Check Server IP and Port parameter setting. 3Check is using 3G or WIFI for connecting, if 3G check the 3G Model WCDMA or EVDO and related SIM card, 3G antenna connect normally/APN setting/Center No.
Q:Device Online but can not see video. A:1Please set Low Sub-stream, when sub-stream set high it will effect the transmission because of the network. Q: Device works well in the Client, but cannot see the video a period time later. Check if connect to server successfully on device, if dialing probably SIM Card no 3G Flow, change another SIM card for testing. Check if Device Number be changed, if yes, need add device to server again.
If still can not view video after previous 2 steps, please check if 3G module error. Q: Video Lost in certain channel? A: Possible reasons are as follows. This channel has no video input. The camera of this channel breaks down or work abnormality.If the camera takes an electricity power from the equipment directly, may be the. Equipments electric voltage isn't enough to make camera work as usual. D The cable that links this channel has problem. Q: Cant playback files on PC successfully? A: Possible reason is as follows. Have never chosen a record file or document path; please choose the path that records file first before playback. Q: Remote control not works?
A: Probably of the reasons are as follows. The remote control didn't pack battery. Q: During playback, the map doesn't show?
A: Possible reasons are as follows: Net cable did not connect to PC; Net works, but the computer can not get to the Internet. Q: When SD card and HDD records, How is the record coverage? A: SD card and HDD will record circularly for each other. When they are full, they will delete the original video records respectively.All items will be checked before packing. All items are new and of high quality. We will reply you within 24- 48 hours.
The item "4CH AHD Car Bus Mobile DVR SD 3G Wireless GPS Realtime Video Recorder+4 Cameras" is in sale since Monday, October 16, 2017. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Exterior\Mouldings & Trim".
The seller is "cute_uu2010" and is located in CN. This item can be shipped worldwide.